| |
1.
UNDERPANEL AND WHEEL AREAS-
This is the
first part of your wash process. Why? Because 90% of all road grime, tar
and excessive buildup of dirt is on these areas. Do not use any of this
bucket's contents in the next step.
- First, prepare
a wash bucket with soap and water. Use a medium to heavy mix of soap
with water. Use an old terry towel and wheel brush in this step.
- Next, apply water
to the under panel and wheels, doing one side of the car at a time.
NOTE: Do not get any water on the upper sides or the top of car for
this step.
- After you have
finished with all under areas, including the front bumper area and rear
bumper area, you are ready for the next step.
2.TOP,
HOOD, TRUNK, AND SIDE AREAS-
Prepare
your second bucket with a light soap mix, using clean mitt and fresh contents
in this bucket. Start this process by squirting off the car from the top
area down, getting as much surface dirt as possible to rinse off of the
car before you use the mitt. Starting with the top surfaces (trunk,
top and hood) you use this fresh mild soap solution. Before doing the
sides, rinse off the top surfaces, starting with the highest point of
the vehicle.
3.
NOW IT IS TIME FOR THE DRYING STEP-
Start with your clean
wet chamois, all wrung out, drying all the top surfaces first. Then proceed
to the sides. Do not use the chamois on the
underpanels and wheel areas. After you dry with the chamois,
proceed to dry off the wheels and under areas with the old terry towels.
Drive the car around the block and again go over the top areas with the
chamois, and then dry the bottom areas
with
the terry towels.
|