| |
1.
UNDERPANEL AND WHEEL AREAS-
This is the
first part of your wash process. Why? Because 90% of all road grime, tar
and excessive buildup of dirt is on these areas. Do not use any of this
bucket's contents in the next step.
- First, prepare
a wash bucket with soap and water. Use a medium to heavy mix of soap
with water. Use an old terry towel and wheel brush in this step.
- Next, apply water
to the under panel and wheels, doing one side of the car at a time.
NOTE: Do not get any water on the upper sides or the top of car for
this step.
- After you have
finished with all under areas, including the front bumper area and rear
bumper area, you are ready for the next step.
2.TOP,
HOOD, TRUNK, AND SIDE AREAS-
Prepare your second bucket
with a light soap mix, using clean mitt and fresh contents in this bucket.
Start this process by squirting off the car from the top area down, getting
as much surface dirt as possible to rinse off of the car before you use
the mitt. Starting with the top surfaces (trunk, top and hood)
you use this fresh mild soap solution. Before doing the sides, rinse off
the top surfaces, starting with the highest point of the vehicle.
3.
NOW IT IS TIME FOR THE DRYING STEP-
Start with your clean wet chamois,
all wrung out, drying all the top surfaces first. Then proceed to the
sides. Do not use the
chamois on the underpanels and wheel areas. After you
dry with the chamois, proceed to dry off the wheels and under areas with
the old terry towels. Drive the car around the block and again go over
the top areas with the chamois, and then dry the bottom areas with the
terry towels.
|